Finalised Tilt-table Benchwork (including measurements)

Finally, after all the discussions and comments from fellow modellers and having sleepless nights how best to realise my tilt-table benchwork, here is the result. I have put down the measurements so that you too can build one. What is important to note is that you can adjust the size of your tabletop. I am doing 240cm (L) x 120cm (W) x 15cm (H) using two equal frames. This translates to about 8ft (L) x 4ft (W) x 0,5ft (H). You can have smaller or larger tabletop to suit your need; the largestever made was 5ft x 9ft by Suzan. The side support panels should remain the same dimensions. The rest should be adjusted accordingly.

IMG_4271

I hope to get this benchwork installed before end of this month so that I could start working on my layout.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s